Do-it-yourself side trellis + DRAWING
HOW TO MAKE THE PORTABLE ADDITIONAL TALES FOR CUCUMBERS BY YOUR HANDS
In a small area, it is necessary to rationally use every piece of land. Therefore, it is not the first year for growing zucchini, cucumbers or eggplants I use high beds complete with attached trellises.
1. On a computer simulated a sketch of a future design with dimensions (see drawing) and printed it.
2. From the boards with a section of 80 × 40 mm, I assembled a frame measuring 240 × 110 cm. On it, using wire staples (photo 1), I fixed a metal mesh with a mesh of 150 × 150 mm (as shown in the figure).
3. For self-tapping screws from the same board, I assembled a smaller frame measuring 140x100 cm (photo 2).
4. Using bolts pivotally connected both parts at a distance of 160 cm from the lower edge of the larger one. The finished structure was treated with protective impregnation on wood and installed over the Garden (photo 3). At the end of the summer season, I add the trellis and put it into the barn.
Reference by topic: Tapestries in the garden with their own hands
SUPPOSED TALES OWN HANDS - DRAWING
OWN TRAINS BY HANDS FOR CROCHING PLANTS - VIDEO
© Author: Gennady Sudnik, Photo by
NOTE: RELIABLE SUPPORT FOR FLOWERS FROM THE PROFILE TUBE OWN HANDS
On the way to the country, we stopped at the market, where my wife bought Clematis seeds. Already at the place of the spouse, she said that the plant is climbing and that it needs support. I decided not to put it in a long drawer, and made a simple structure from scraps of a profile pipe.
- From a profile pipe with a cross section of 30 × 20 mm, he cut off two blanks with a length of 1800 mm (sidewalls) and one with a length of 700 mm (upper bar).
- I decided to make the lower crossbar of the support from a metal corner with a shelf of 30 mm, since a thin-walled pipe in contact with almost constantly moist soil quickly rusts.
- From the prepared materials, I welded the frame by laying pipes on the rib on the side of 30 mm. Immediately cleaned up all the seams in the corners.
- Then I welded into it pipe segments with a section of 15 × 15 mm diagonally, starting from the middle, and then on both sides of it at an equal distance. I cut the blanks to the desired size with a grinder, fitting them in place.
- After welded into the frame the same number of crossbars, but in a different direction.
- An arc from a pipe with a section of 30 × 20 mm was welded from above to the frame, and three pins from a corner with shelves of 30 mm were used to install support on the bed from below. The finished product was painted with PF-115 enamel.
© Author: Valery Vasilyuk, Photo by the author
Below other entries on the topic "Dacha and garden - with their own hands"
- Curbs in the country - what to choose and make: pros and cons
- Where to store vegetable harvests if there is no cellar?
- DIY baskets for giving from plastic bottles - photo
- Do-it-yourself mini-waterfall "Koryaga"
- Do-it-yourself hydrolat from your flowers - beautician advice
- Do-it-yourself fence in the country house: without holes, concrete and alone - how I built it (+ drawings)
- Do-it-yourself flat-cut shovel
- How to make a flower bed-pyramid with your own hands
- DIY pipe lifter
- Placing buildings on a small summer cottage - architect's advice
Subscribe to updates in our groups and share.
Let's be friends!